To ensure safe enjoyment and understanding of your aquarium please read and
follow all the safety instructions and important notices below before using at
setting up your aquarium. Failure to do so may result in injury or damage to the
unit.
SAFETY
Important!
Disconnect the mains electricity supply before carrying out any
installation or maintenance of any kind. Do not attempt to modify this unit in any
way and only use the recommended parts for replacement.
·
Prior to set up, carefully inspect the tank to ensure it is not fractured or
cracked.
·
If the lighting unit falls into the water, DO NOT touch it! First unplug it and
then retrieve it. If the electrical components of the appliance get wet,
unplug the appliance
immediately
.
·
Inspect the unit carefully after installation. This should not be plugged in if
there is water on parts that are not intended to get wet.
·
Do not operate the unit if the plug or cord is damaged; if it is malfunctioning;
or if it has been dropped or damaged in some way.
·
Do not yank cord to pull plug from outlet. Grasp the plug and pull to
disconnect. Always unplug from an outlet when not in use.
·
The power cord of this appliance cannot be replaced; if the cord is
damaged, the appliance should be discarded. Never cut the cord.
·
All connections must be earthed. Do not connect to any voltage other than
that stated.
·
If the plug or socket does get wet,
DO NOT
unplug the cord. Disconnect the
fuse or circuit breaker that supplies power to the appliance. Next, unplug
and inspect for any presence of water in the power socket.
·
To avoid the risk of the unit plug, switch or wall socket getting wet, position
the unit to one side of a mounted wall socket to prevent water from dripping
into the socket or plug.