·
A “drip loop” should be arranged to the socket. The “drip loop” is that part of
the cord below the level of the socket (or the connector if an extension cord
is used), to avoid water travelling along the cord and coming into contact
with the wall socket.
·
Do not attempt to modify this unit in any way and only use the
recommended parts for replacement.
·
ALWAYS disconnect from the power supply before removing the hood.
·
If an extension cord is required, a cord with a suitable rating should be used. A
cord rated for less amperes or watts than the appliance rating may cause the
unit to overheat. Care should be taken to position the cord so that it will not be
pulled or cause a trip hazard.
·
If the unit shows any signs of water leakage, disconnect the power supply
cord from the wall socket and consult All Pond Solutions or the retailer you
purchased this unit from for further advice.
CAUTION
·
NEVER place any object(s) on the LED strip light. Make sure there is
adequate air space around the light. The safety and correct functioning of
your aquarium is only guaranteed if the lighting and all other equipment has
been correctly installed.
·
Ensure supplied powerhead is fully submerged at all times to avoid
overheating damage.
·
To prevent injury, do not touch moving parts or hot parts such as heaters or
LED devices.
·
Always unplug or disconnect equipment from the electricity supply before
placing hands into your aquarium water and before installing or removing
parts. Always unplug equipment from the mains when not in use.
·
Do not use any equipment other than for its intended purpose (i.e. for
outdoor pools, ponds, household use, etc.).
Do not
use attachments or
spare parts other than those recommended or sold by the unit
manufacturer.