Unbox the SKIM-2 and check all parts are present.
Wash the filter floss through until clear with aquarium
water and place into the top area of the SKIM-2.
Place the surface strainer inside the top area of the
SKIM-2 above the filter floss.
If required, connect the venturi air pipe to the top
connector on the outlet.
Position the SKIM-2 inside you aquarium against the
aquarium glass using the included suction cup
attachments.
Make sure when positioning the SKIM-2 that the
surface strainer is able float up and down with the
surface level.
Insert the SKIM-2 plug into the mains, ensure you
have a drip loop present (
see image 1
).
If required, adjust the surface strainer height using the
dial on the front of the SKIM-2 (
see image 2
).
If you attached the venturi air pipe, adjust the flow of
oxygen / bubbles by twisting the venturi adjuster
(
see image 3
).
INSTALLATION AND USE
3
2
1
4
5
6
7
8
9
SKIM-2
AQUARIUM
TANK
POWER SUPPLY
CORD
DRIP LOOP
image 1
image 2
image 3