All
SportSystems, Inc.
©
2020.
STEP 4 - Attach Bracket to Projector
Note: Each projector will have different mounting locations and some will have 4
mounting holes others only 3.
Locate the mounting bracket. Determine the
number of mounting locations available on your
projector. Some projectors have 4 holes others
have only 3. If there are only 3 mounting holes
then you can remove one of the arms from the
mounting bracket. Shown to the left is the
bracket with one of the arms removed.
Use plastic spacers and washers between
projector and feet.
Install feet to the bottom of the projector using
the provided screws.
Do not
over tighten. There
are extra screws with varied of sizes.
Slide each arm of the Mounting Bracket onto the
feet already attached to the bottom of the
projector. Initially keep the screws loose to allow
the arms and mount move freely until you locate
the center of balance position for the mount.
When positioned correctly the projector will hang
level when suspended from the hooks on the
mount. Once proper position is obtained tighten
screws.
Do not
over tighten.
Page 7 of 8
Rev July, 2020
