Allstar Performance 8300 Lane Dr., Watervliet, MI 49098
Phone: (269) 463-8000 Fax: (800) 772-2618 www.allstarperformance.com
Form 1174
Page 2 of 4
Rev. 050219
INSTALLATION INSTRUCTIONS
Tear-Off Machine
7.
Also check that the installation will not interfere with the shield pivot points, side air input ports or
shield opening and closing.
8.
If hole placement or interference is a problem, reposition tear-off machine if possible. If repositioning
is not possible you may not be able to use this machine with this style helmet.
9.
While unit is clamped to shield mark the backside of the shield with a marker to show the inside and
outside edge of the Velcro located on the tear-off machine. Marking the inside and outside will help
with placement of the Velcro strips that are installed in Step 13.
10.
Remove protective film or food wrap from front of shield and clean shield with rubbing alcohol pad
provided making sure to remove any dirt or oil from outside of shield.
11.
Prep front of shield Velcro mounting area with primer 94 provided using the guidelines on the bac
side of shield from Step 9. Pinch the black dot on 3M Primer 94 to start flow. Use primer ONLY in the
Velcro mounting areas, being EXTREMELY careful not to get primer on viewing area. Let primer dry
completely (about 5 to 10 minutes).
12.
Cut the Velcro into four strips matching for the Velcro on the unit using the guidelines as a template.
These will be attached to the shield in the next step.
WARNING:
You only have one chance to get this next step right; once you touch the Velcro adhesive to the
shield you cannot reposition it without damaging the adhesive.
13.
Remove the backing material from Velcro strips and mount to the shield without touching the
adhesive tape surface with your fingers. Use the guidelines on the backside of shield from Step 9 to
properly position the Velcro strips.
14.
Press the Velcro strips firmly in position trying to remove all air bubbles. Let Velcro adhesive cure for
72 hours before any use.
15.
Remove the black aluminum film housing from the film guide lens.
16.
Install the film guide lenses onto the shield with Velcro fully engaged.
17.
With the film guide lenses Velcroed into position; using a ¼” drill from the outside of the shield drill
the two quick release mounting holes using the holes in the lens as the guide.
18.
Remove film guide lens from the shield and install the two quick release pins into the backside of the
shield and use the E-clips on the front side to hold pins in place.
19.
Re-install black aluminum film housings onto the lens.
20.
Install the machine on shield starting with new film housing side ¼”quick release pin and clip. Work
Velcro together from new film housing side to motor housing side, then install second clip to
complete installation of tear-off machine to helmet shield.
