AllTrade AIR-PLUS 691164, Operation Manual

• For the nailer/stapler to operate, your finger must first be off the trigger and the work contact element

of the nailer/stapler then pressed against the work piece. Once the work contact element is pressed
against the work piece, pull the trigger to drive the fastener into the work piece.

• Release the trigger after each fastener is driven.

• Move the nailer/stapler to the next location and repeat the procedure above.

• Test for proper fastener penetration by driving nails into a sample piece of wood. If the fasteners do not

achieve the desired penetration, adjust the air pressure to a higher setting until the desired penetration
is achieved.

Clearing a Jam from the Nailer/Stapler:

FASTENER JAMMED IN FASTENER DISCHARGE AREA:

• Disconnect air nailer/stapler from air hose.

• Open the nozzle, grab jammed fastener with pliers and remove.

FASTENER JAM INSIDE THE MAGAZINE:

• Disconnect air nailer/stapler from air hose.

• Pull back on the magazine cover.

• Open the nozzle and remove jammed fastener.

• Push the magazine cover forward until the latch catches.

Cleaning the Nailer/Stapler:

DISCONNECT THE NAILER/STAPLER BEFORE CLEANING AND INSPECTION.

CORRECT ALL PROBLEMS BEFORE PLACING NAILER/STAPLER BACK IN USE.

NEVER USE GASOLINE OR OTHER FLAMMABLE LIQUIDS TO CLEAN THE

NAILER/STAPLER. VAPORS IN THE NAILER/STAPLER WILL IGNITE WHEN NAILER/STAPLER IS IN
USE AND CAUSE THE NAILER/STAPLER TO EXPLODE, WHICH WILL RESULT IN DEATH OR SERI-
OUS PERSONAL INJURY.

• Disconnect air nailer/stapler from air hose.

• Remove tar buildup with kerosene #2 fuel oil. Dry off nailer/stapler completely before use.

• NOTE: DO NOT SOAK nailer/stapler in cleaning solutions or damage may occur.

Service and Repairs:

• All quality nailers will eventually require servicing or replacement of parts due to wear from normal use.

These operations should only be performed by a licensed professional technician. Never try to repair
the nailer/stapler by yourself. For service, call 1-800-423-3598.

TROUBLESHOOTING GUIDE

DISCONNECT NAILER/STAPLER FROM AIR SUPPLY BEFORE PERFORMING

ANY SERVICE PROCEDURE.

WARNING

DANGER

WARNING

8