9
ALLTRONIC GmbH, Raiffeisenstraße 11, 89438 Holzheim
Service-H49 9075 95 88 3-28
Step 7: Turn on the UPS
Press the ON/Mute button on the front panel for two seconds to power on the UPS.
NOTE:
The battery charges fully during the first five hours of normal operation. Do not expect
full battery run capability during this initial charge period.
Step 8: Install software
For optimal computer system protection, install UPS monitoring software to fully configure UPS
shutdown. Use supplied RS-232 or USB communication cable to connect RS-232/USB port of
UPS and RS-232/USB port of PC. Then, follow below steps to install monitoring software.
1.
Insert the included installation CD into CD-ROM (The newest Software, you can download
to www.alltronic-net.de) drive and then follow the on-screen instructions to proceed
software installation. If there no screen shows 1 minute after inserting the CD, please
execute setup.exe file for initiating software installation.
2.
Follow the on-screen instructions to install the software.
3.
When your computer restarts, the monitoring software will appear as an orange plug icon
located in the system tray, near the clock.
2-5. Battery Replacement (Only for RT Models)
NOTE:
This UPS is equipped with internal batteries and user can replace the batteries without
shutting down the UPS or connected loads.(hot-swappable battery design) Replacement is a
safe procedure, isolated from electrical hazards.
CAUTION!!
Consider all warnings, cautions, and NOTEs before replacing batteries.
NOTE:
Upon battery disconnection, equipment is not protected from power outages.
Step 1
Step 2
Step 3
Remove front panel.
Disconnect battery wires.
Pull out the battery box by
removing two screws on the
front panel.
It’s in closed status for UPS
normal operation as default.
To activate EPO function,
remove these two screws.
