7
EN
Quick Start guide
Connect
1.
Connect the cables and the antenna.
2.
Press the button on the remote control to turn on TV from standby mode.
Initial Setup
When the TV is initially powered on, a sequence of on-screen prompts will assist in
configuring the basic settings.
1.
Select the desired OSD (On Screen Display) language. Press the
buttons,
then press OK.
2.
Select the country. Press the
buttons to select the country, then press OK
to start channel tuning.
Turning the TV on and off
Turn the TV on – Connect the power cable. The TV will enter in standby mode. Press the button from
the remote control to turn on the TV from standby mode.
Turn the TV off – Press the
button from the remote control to enter into standby mode.
Do not leave your set in standby mode for long periods of time. It is best to unplug the TV from the
cables and the antenna.
No signal – There is a No Signal menu on screen when there is no input signal. In TV/DTV mode, if
there is no signal for 15 minutes, the TV will automatically turn off.
Program Selection
Use the CH+/CH- buttons from the TV or the remote control.
Press CH+ to increase the channel number.
Press CH- to decrease the channel number.
Using the 0-9 digital buttons, you can select the channel number by pressing 0 to 9. (In TV and DTV
mode).
Volume adjustment
Press the VOL+/- buttons to adjust the volume.
If you want to switch off the sound, press the MUTE button.
You can deactivate the mute state by pressing the MUTE button or increasing/decreasing the volume.
Changing the input source
You can select the input source by pressing the button on the remote control.
Press the UP/DOWN arrows to cycle through the input source, and press OK to confirm your choice.
