PAGE
46
ALMAC s.r.l.
Attention: the 20A recharge is only necessary if a current is available from the
panel of max 10Aac, but, mainly,
use the 40A recharge to maintain the
optimal state of the batteries.
3.3
Operating safety devices
Attention: Periodically verify that the safety devices are operating correctly.
During work, the operator must be able to assess, recognise and avoid all
dangers and must immediately inform the persons in charge of any faults in the
safety devices so that they can be inspected and restored to their original
conditions of safety and reliability.
DO NOT TAMPER WITH AND DO NOT CHANGE THE CALIBRATION OF ANY OF
THE COMPONENTS OF THE ELECTRICAL AND HYDRAULIC SYSTEM.
The machine includes a complete set of safety devices.
3.3.1
Main frame inclination control device
On the machine Frame there is a Can Bus angle sensor that constantly
communicates the inclination measured to the electronic control unit.
The angle sensor is redundant (thus consisting of two separate sensors) and the
X and Y inclination axes of the machine are monitored (lateral and longitudinal).
The signals of the two sensors are constantly compared with each other to assess
their consistency.
Summary of Contents for MULTI-LOADER 2.5
