U S E O F T H E A P P L I A N C E
U S E O F T H E A P P L I A N C E
• The best working environment for the humidifier is : temperature between 5°C and 40°C and moisture
less than 80% HR.
• Soak the descaling cartrigde 15 minutes before the first use.
• At first use let the appliance half an hour in the room before using so that the moisture sensor is
completely efficient.
• Clean the water tank as well as the water flume before first use and after no use for long time.
• This product is equipped with a descaling cartridge which has to be cleaned every two months or
when white dust appears on the cartridge.
FILLING
• Take out the water tank from the base. Unscrew the water tank cap located under the tank. Fill the
tank with water (water temperature should be less than 40°C). Screw tightly the tank cap and replace
the water tank on the base. Replace the cap of the mist spray mouth (1). Plug the appliance.
ON/OFF :
• Press M/A key (16), the appliance begins working and operating light indicator lights on. LCD screen
shows humidity rate. Press the key again and the appliance stops working.
“MO” :
• this key (15) allows you to choose moisture level
• Press this key to select the rate from 20% to 90% (level of 5%)
• The screen flashes during 5 seconds then shows the ambient moisture rate. If ambient moisture level
is up to the moisture level preselected, the appliance stops working automatically.
“ MOISTURE – “:
• This function is the same as “Mo” in opposite order : 90% ; 85% ; 80% … 25% ; 20%)
Pressing this key (14) decreases moisture level from 90% to 20% (level of 5%)
IONIZER FUNCTION :
• By generating negative ions, the ioniser function allows to restore air electric balance and gives a
well-being sensation.
• Press Ionizer key (13), ionizer function is operating. Ionizer indicator flashes on the screen.
(See photo below)
• Press the key again to stop ionizer function. Indicator goes out.
9
ionizer function
indicator
notice_hu62E:notice_hu60.1_et 5/02/09 11:06 Page 9
