5
Step III. Pair your headphones to your device(s)
Normal Pairing
The HX101 is a wireless headphone and needs to be paired to your computer or mobile
device before using (to ensure your product is compatible, see “Compatibility” on page 7).
Even better, the HX101 is equipped with Bluetooth 4.1, allowing it to be connected to two
devices at the same time (only one device can be actively connected and playing at any
given time)! To pair the headphones with the first device,
1. Make sure the HX101 is turned OFF. If your headphone is ON (LED light blinking),
turn it off by pressing and holding the Multifunction Button for 3seconds.
2. Place the HX101 in pairing mode by pressing and holding the Multifunction Button for
8 seconds. After 3 seconds, the headphone will turn on and the LED will flash blue. It
is important to continue to hold down the button until the LED flashes blue and red
rapidly. At this time, the headphone is in pairing mode.
3. On your computer or mobile device, make sure that Bluetooth is turned ON, and that
your device is discoverable.
4. On your computer or mobile device, search for available Bluetooth devices. Find and
select “Alpatronix HX101”. Most devices don’t require a password for pairing, but if
prompted, enter “0000”.
5. Your device should be paired to the HX101 without any problems. If pairing is
unsuccessful, repeat steps 1 - 4. If you are still unsuccessful, contact Alpatronix
Customer Service for help.
Note: The HX101 is programmed to turn off after 2 minutes of being disconnected from a
mobile device. This is a power-saving measure designed to keep your headphone’s
battery from draining in the event that you forget to shut it off before leaving.
Pairing with a Bluetooth transmitter
To pair the HX101 with a Bluetooth transmitter, please follow the steps below:
1. Keep your headset and transmitter within 3ft of one another.
2. Place the headset into pairing mode.
3. Turn the Bluetooth transmitter ON and place it in pairing mode. It will automatically
search for Bluetooth devices and send a pairing request.
4. If a code is needed, the transmitter will automatically enter “0000”.
Pairing with two devices simultaneously
The HX101 can pair with two Bluetooth devices simultaneously (multi-pairing) and take calls
from any of them. After pairing with the device #1, turn the headset off and repeat the
pairing procedure with device #2. Once pairing with device #2 is successful, turn the
headphone off, and then turn it back on again. The headset will automatically connect to
the phone it was paired with last (device #2). Press “Volume +” and “Volume -”
