Installation & Systems Manual RUBIDIUM SERIES
Page 21
1.4.3
Installation of a Module
Install a module using the
PC program „RUBIDIUM CONFIGURATION“
or the
RUBIDIUM SERIES HTTP Server.
Once the communication to the module has been started, the operating parameters can be
displayed and changed.
Check all parameters to obtain a proper configuration for your application. Some modules
offer a wide range of functions. You may enable or disable functions. It is recommended to
enable only those functions which are necessary for your application.
Please notice the description of the software tools in this manual. If you have further questions,
please contact your local dealer or
AlVelte
directly.
1.4.4
Update
Most of the RUBIDIUM SERIES modules can easily get a new firmware by flash programming.
The software to do this flash programming is part of the PC program “RUBIDIUM CONFIGU-
RATION“. A
.tcf
file will be supplied/available if it becomes necessary to update a module.
Run the PC program “RUBIDIUM CONFIGURATION“, select the appropriate module’s
address, and click the “Flash Update“ button. The program will then ask you to locate/open
the appropriate
.tcf
file.
Details to the flash update of a single module are given in the description of the individual
module.
During the flash update the operation of the module stops!
