Installation & Systems Manual RUBIDIUM SERIES
Page 86
4.2.6
The “Functions“ Page
As soon as a communication to a single module has been established, the
Configuration
page gives a list of all the links which correspond to all the currently available or used pages
of this specific module.
Click on the
Functions
link to get an overview of all possibly available pages and to activate
or deactivate pages.
Each link in this list (each page) reflects a
function
of the module. The columns
Edit
and
Use
determine whether the function in the module is activated/deactivated and whether it is
possible to change the set-up of that specific function.
Click on the applicable
Edit
and/or
Use
check-boxes to activate/deactivate a function.
Edit
Use
Function is deactivated, the link is not visible.
Function is activated, the link is visibly and a configuration is possible.
Function is activated but the link not visible, and therefore this function is
not configurable at the moment.
We suggest that you deactivate the
Use
check-boxes of all functions you are presently
not using.
We suggest that you deactivate the
Edit
check-boxes of all functions you are presently
not configuring. That avoids unintentional operating and malfunctions.
Attention:
Any change of a set-up has to be confirmed always by clicking the “
Save To
Module
” button. Only this transfers and stores the new set-up to the module.