ADM-PCIE-9V5 User Manual
3.1.1 Switches
The ADM-PCIE-9V5 has an octal DIP switch SW1, located on the rear side of the board. The function of each
switch in SW1 is detailed below:
Figure 7 : Switches
Switch
Factory
Default
Function
OFF State
ON State
SW1-1
OFF
User Switch 0
Pin AW33 = '1'
Pin BF52 = '0'
SW1-2
OFF
User Switch 1
Pin AY36 = '1'
Pin BF47 = '0'
SW1-3
OFF
Reserved
Reserved
Reserved
SW1-4
OFF
Power Off
Board will power up
Immediately power down
SW1-5
OFF
Service Mode
System Monitor normal
operation
System Monitor Service Mode
(firmware update etc.)
SW1-6
ON
HOST_I2C_EN
System Monitor connected to
PCIe slot I2C
System Monitor isolated from
PCIe slot I2C
SW1-7
ON
CAPI_VPD_EN
OpenCAPI VPD PROM
connected to PCIe slot I2C
OpenCAPI VPD PROM
isolated from PCIe slot I2C
SW1-8
ON
OpenCAPI_VPD_WP
OpenCAPI VPD is write
protected
CAPI VPD is writable
Table 3 : Switch Functions
Use I/O Standard "LVCMOS18" when constraining the User Switch pins.
Page 7
Functional Description
ad-ug-1385_v1_0.pdf