DEU
ENG
FRA NDL ITA ESP DAN/NOR
FIN
SWE POL RUS
22
Commissioning
Alpha IP WRC2 61001
5.2 Installation
The battery operation allows a free choice of the installation place. The
device can be installed in the supplied interchangeable frame by fixing
the mounting plate with screws or with adhesive tape. An integration
into an existing switch series is also possible.
5.2.1 Installation with adhesive strips
Depending on the surface, installation can be performed with the sup-
plied double-sided adhesive tape or with the supplied screws. Installation
is possible on different surfaces as e. g. masonry, furniture, tiles, or glass.
Ö
The commissioning is finished and the device is readily assembled.
1. Select a suitable installation position.
In case of an installation with adhesive strips the installation surface
must be even, smooth, undamaged, clean, and free from grease and
solvents.
2. Remove the protective foil from one side of the adhesive strip.
3. Stick the adhesive tape on the back side of the mounting plate in the
recesses provided for this purpose (see fig. left).
4. Remove the protective foil from the other side of the adhesive strip.
5. Align the device horizontally at the desired position and press it on
the surface.
5.2.2 Installation with screws
Ö
Select a suitable installation position.
1. Ensure that no lines are laid at this position.
2. Remove the mounting plate from the device.
3. Position the mounting plate on the installation place. The arrow on
the front of the mounting plate must show upwards.
4. Align the mounting plate horizontally.
5. Mark two diagonally opposite bores using the mounting plate as a
template (see fig. left).
6. For stone walls, drill the marked holes with a 5 mm masonry drill.
If wooden walls are present, the screws can be directly screwed into
the wood. Pre-drilling with a 1.5 mm wood drill facilitates the screw
installation.
G
H
J
I
J
I