15
BACKER PAD AND OTHER APPROVED SPINDLE ATTACHMENTS
This polisher has a 5/8” - 11 center water feed spindle thread.
To attach a polishing backer pad or other approved spindle attachments follow the steps
below:
1. Screw the attachment onto the
spindle by hand as shown in
Figure 11.
2. Tighten with supplied wrench as
shown in Figure 12.
NOTE - If attachment does not thread on freely, check threads on both surfaces for
damage or dirt. Clean, repair or replace as needed to ensure a safe and tight con-
nection to the polisher.
WATER FEED ATTACHMENT
Attach the polisher water line fitting to any garden hose connection.
Figure-11
Figure-12
