010-619-J0 Rev B
Page 2
WARNING
:
Lethal voltages are present within the power system. Always assume that an electrical
connection or conductor is energized. Check the circuit with a voltmeter with respect to the grounded
portion of the enclosure (both AC and DC) before performing any installation or removal procedure.
•
Do not work alone under hazardous conditions.
•
A licensed electrician is required to install permanently wired equipment. Input voltages can range
up to 240Vac. Ensure that the utility power is disconnected and locked out before performing any
installation or removal procedure.
•
Ensure that no liquids or wet clothes come into contact with internal components.
•
Hazardous electrically live parts inside this unit are energized from the batteries even when the
AC input power is disconnected.
•
The enclosure which contains the DC or AC power system along with customer installed radios
must remain locked at all times, except when authorized service personnel are present.
•
Always assume electrical connections or conductors are live. Turn off all circuit breakers and
double-check with a voltmeter before performing installation or maintenance.
•
Place a warning label on the utility panel to warn emergency personnel that a reserve battery
source is present which will power the loads in a power outage condition or if the AC disconnect
breaker is turned off.
•
At high ambient temperature conditions, the internal temperature can be hot so use caution when
touching the equipment.
WARNING
:
The intra-building ports (Ethernet, CAN, Alarm relays) of the equipment or subassembly are
suitable for connection to intra-building or unexposed wiring or cabling only. The intra-building ports of
the equipment or subassembly MUST NOT be metallically connected to interfaces that connect to the
OSP or its wiring. These interfaces are designed for use as intra-building interfaces only (Type 2 or Type
4 ports) and require isolation from the exposed OSP cabling. The addition of Primary Protectors is not
sufficient protection in order to connect these interfaces metallically to OSP wiring.
WARNING
:
Controller Ethernet port is not designed to withstand lightning and AC power cross surges
according to the NEBS requirements in GR-1089-CORE. Ensure that any Ethernet cable used (not
provided by Alpha) does not exceed a maximum length of 6 meters.
1.4
Battery Safety
•
Never transport an enclosure with batteries installed. Batteries must ONLY be installed after the
enclosure has been securely set in place at its permanent installation location. Transporting the
unit with batteries installed may cause a short circuit, fire, explosion, and/or damage to the battery
pack, enclosure and installed equipment.
•
Servicing and connection of batteries must be performed by, or under the direct supervision of,
personnel knowledgeable of batteries and the required safety precautions.
•
Batteries contain or emit chemicals known to cause cancer and birth defects or other reproductive
harm. Battery post terminals and related accessories contain lead and lead compounds. Wash
your hands after handling batteries.
WARNING
:
Follow battery manufacturer’s safety recommendations when working around battery
systems. Do not smoke or introduce an open flame when batteries (especially vented batteries) are
charging. When charging, batteries vent hydrogen gas, which can explode.
Summary of Contents for Cordex HP 48 1.2kW
