25
0913000-J0 Rev D
6.1.2 Setting the Anchors
First, review manufacturer's instructions before setting the anchor.
1. Drop the anchor into the drilled hole.
2. Insert the anchor setting tool and hit it with a hammer to expand the anchor until the collar of the setting tool
rests against the shoulder of the anchor.
6.2 Placing and Securing the Bay
6.2.1 Securing the Bay to the Floor
NOTE:
It is extremely important that the bay be properly shimmed in order to prevent any frame
distortion. If the floor is not level, shims may be required.
1. Place the bay in position over the anchoring holes (and the isolation pad if applicable).
2. Install the anchoring hardware for each anchor FINGERTIGHT.
3. Check that the bay is level front-to-back and side-to-side. Install shims if necessary.
4. Once the bay is level, tighten all bolts to the appropriate torque.
Figure 14 — Securing power system bay to concrete floor
