18
2. INSTALLATION
2.3 Pedestal Mounting
Mount the bracket with three,
1
/
4
–20 bolts /studs.
Install electrical conduits between the UPS and
the host equipment. If a control or communica-
tions signal is connected, a separate conduit is
used.
Figure 2.6
Mounting the Bracket onto the Floor
4
3
STEP 2: Attach the UPS to the Pedestal
DANGER: Turn the battery breaker OFF.
The UPS supplies lethal power levels
without being hooked up to line power.
Unlock and open the enclosure. There are two
connections between the enclosure halves; a
grounding wire and a nylon rope. Disconnect
both and then set the enclosure front aside.
Mount the rear enclosure to the pedestal
mount's rear.
Connect the two parts together with the three
1
/
4
inch screws in the mounting kit.
Install conduits and wires for connecting the
UPS to the load(s) and line power.
Figure 2.7
Mounting the UPS onto the Pedestal
1
4
3
2