GENERAL SAFETY REGULATIONS
WARNING: The warnings, cautions, and instructions
discussed in this instruction manual cannot cover all
possible conditions or situations that could occur. It
must be understood by the operator that common
sense and caution are factors that cannot be built into
this product, but must be supplied by the operator.
1. Keep the work area clean and dry. Damp or wet work areas can result in
injury.
2. Keep children away from work area. Do not allow children to handle this
product.
3. Use the right tool for the job. Do not attempt to force small equipment to do
the work of larger industrial equipment. There are certain applications for
which this equipment was designed. It will do the job better and more safely
at the capacity for which it was intended. Do not modify this equipment, and
do not use this equipment for a purpose for which it Was not intended.
4. Check for damaged parts. Before using this product, carefully check that it
will operate properly and perform its intended function. Check for damaged
parts and any other conditions that may affect the operation of this product.
Replace damaged or worn parts immediately.
5. Do not overreach. Keep proper footing and balance at all times to prevent
tripping, falling, back injury, etc.
6. DO NOT use the equipment when tired or under the influence of drugs,
alcohol, or medication. A moment of inattention while operating this
equipment may result in serious personal injury.
7. Ensure that only the qualified electrician can installs/services this cord
reel.And it must not be used by children or unskilled persons.
8. Ensure that power supply voltage does not exceed maximum voltage rating
of reel.
9. Ensure that reel is properly be installed before connecting to power supply.
10. Ensure that all electrical power is removed form reel before servicing.
11. Check for frayed and broken wires before each use.
12. When pull electrical cord from the reel always grasp the electrical cord itself, not
the work device.
13. Remove power from the reel immediately when any malfunction occurs.
14. Never remove, tamper with or cut the safety devices fitted by the manufac-
ture.
