28
Instructions for the installer
3.11 ON-SITE MEASUREMENT OF THE
COMBUSTION EFFICIENCY
3.11.1 ENABLE THE CALIBRATION
FUNCTION
ATTENTION!
Function reserved exclusively to Authorised Service
Centres.
ATTENTION!
Thi
s function is explained in chapter 6 (Generator
control) of the HSCP installation and maintenance
manual.
3.11.2 POSITIONING THE PROBES
In order to determine the combustion
efficien
cy, the following meas-
urements must be taken:
- measure the combustion air temperature
- measure the
fl
ue gas temperature and content of CO
2
withdrawn from
the hole 2.
Take the spe
cific m
easurements with the generator at full speed.
ATTENTION!
Remove cap 2, insert
the CO
2
analysis probe
into the hole.
Probe
flue gas
Summary of Contents for ARES Pro 150
Page 2: ......