010-353-B9-001 Rev. A1 (09/2015)
10
Fig. 2-1, Removing the FlexPoint cover
The following procedures will differ slightly for 1208-F and FP-1232-D / 1250-D applications.
NOTICE:
Note the polarity of the wiring harness. Improperly connecting these wires can cause faulty
operation and void the warranty.
The power supply cord is used as the main disconnect device. Verify that the equipment is
installed near the AC receptacle and that the cord is easily accessible.
Always mount the unit in a vertical orientation with 6" (15.2 cm) of space above and below,
2–4" (5–10 cm) in front and 2" (5 cm) of space on both sides to provide adequate thermal
ventilation.
2.0 Installation
2.1 Installation and connection
2
3
1
A. Unpack and inspect the unit.
B. The unit is designed for use in an indoor environment with a maximum ambient
temperature of 45°C/113°F. Install the unit within 8' (2.4 m) of an AC receptacle.
C. Remove battery compartment cover by pressing the finger tab underneath the middle of
the unit (1) and pull the cover bottom away from the unit (2) and down (3).
CAUTION!
Summary of Contents for FP1208-F-5A
Page 19: ......