user regarding how to install or remove this RF module in the users manual of
the end product which integrate this module.
The users manual for OEM integrators must include the following information
in a prominent location
“
IMPORTANT NOTE: To comply with FCC RF exposure compliance
requirements, the antenna used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not
be co-located or operating in conjunction with any other antenna or transmitter.
We declare this product is limited in CH1-CH11 for 2.4G band by specific
firmware controlled by the manufacturer and is not user changeable.
If the end product integrating this module is going to be operated in 5.15 ~
5.25GHz frequency range, the following warning statement must be included
in the user manual.
The 5.15 ~ 5.25GHz frequency band in US/Canada is restricted to indoor use
only.
Industry Canada Statement
Operation is subject to the following two conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may
cause undesired operation of the device
Antenna having a higher gain is strictly prohibited per regulations of Industry
Canada. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the EIRP is not more than required for