www.alphasonik.com
Operation
(Continued)
Charging the battery
• When not in use but connected to the main power supply, if the speaker is in the OFF
position, the internal battery will be re-charged.
•
When fully charged, the CHARGE LED will turn off.
Powering the Unit On
•
Turn the VOLUME, ECHO and MIC VOLUME controls down and turn the POWER
switch to the ON position.
•
Switch VCV (voice controlled volume) off.
Using the VHF Wireless Microphones
1.
Insert batteries into the hand-held microphones by carefully unscrewing the base of
each one and connecting the “+” and “-” terminals of the battery to the
corresponding clips inside the microphone body. Make sure to observe the
correct polarity.
2.
With the VOL A and VOL B controls turned down, press the VHF ON/OFF button
inwards to the ON position so that the VHF POWER LED switches on. Each
wireless mic’s RF LEDs in turn - will iluminate as a result.
3. Gradually increase VOL controls, testing each microphone in turn for output through
the speaker.
4.
Turning the ECHO control clockwise adjusts a pre-set echo function for singing and
special effects. BASS and TREBLE can be cut or lowered by turning
counter-clockwise or increased by turning clockwise.
5. When not in use, switch the wireless microphones off.
Using VCV Voice Control Volume Switch Function
•
The
VCV
switch will prioritize the microphone over the music playback. When the
VCV is enabled the music will be muted when an announcement is made through the
microphone. This is very useful for announcements during a party,
Using the Remote Control
• In addition to the panel controls, an infra-red remote control is included for the
USB/SD/FM player which provides additional functions to allow greater control
over the media player.
• In order for the remote to function properly, ensure that it is pointed towards the front
of the system.
