- -
10
Table of programming
0 0 n n n n Password nnnn to programming mode access
0 0 0 0
1 1 n n n n Memory x for permitted fix number (1 to 4 digits)
1 2 n n n n
1 3 n n n n
1 4 n n n n
1 5 n n n n
1 6 n n n n
1 7 n n n n
1 8 n n n n
1 9 n n n n
2 1 n Reaction of GSM GATE at disconnection of GSM module
n=0 during disconnection is busy tone on the line
n=1 during disconnection is interrupted loop current
0
2 2 n Acknowledge character setting
n=0 - #
n=1 - *
0
2 3 n Type of dial tone n
n=0
– dial tone according table of tones
n=1
– dial tone of public lines operator
n=2 - quiet
0
2 4 n
Turning on combination for dialling „+„ to mobile phone
n=0
– combination turn off
n=1
– sending „+„ to mobile after „00„ dialling
0
2 5 n Signalization to the call
– short tone each minute
n=0
– tone is turn off
n=1
– tone is turn on
0
2 6 n Restriction of call duration
n=0
– without restriction
n=1
– call duration restricted at 10 minutes
0
2 7 n PIN
n=0
– start without PIN
n=1
– start with PIN
2 8 n Type of acceptable dial of telephone number
n=0
– tone and pulse dial is acceptable
n=1
– pulse dial is acceptable only
n=2
– tone dial is acceptable only
2 9 Indication of signal power. Power is indicated by frequency of short tones.
Max. frequency is 5/ sec.
3 1 n n Ringing after inicialization nn decimal of sec. (00 to 99 it is 9,9 sec)
(„00„ not ringing during inicialization)
0 0
3 2 n n Waiting for last number nn sec. (01 to 15)
(after finishing of dial by acknowledge character is sending immediately)
0 6
3 3 n n Waiting nn sec. for dial after pick up (00 to 99 it is 9.9 sec)
(„00„ waiting is not limited)
0 0
3 4 n n Reaction of BLUE GATE on finishing of dial from GSM module
nn=00
– busy tone
nn=01-19 disconnecting of loop current on set time
0 0
