Installation instruction AV-XL/ML instruction Rev.1.2 15-07-14
3 mounting holes for keypad
2 extra mounting holes
for anti-tamper
protection.
This is only necessary
for Grade 3 compliant
installations
A
B
C
D
Figure 1 – AlphaVision XL / ML keypad front and back plate
From hardware revision 1.7 it is possible to adjust the brightness of the backlight (silicone keypad and LCD display). This also
applies for the volume of the buzzer.
Brightness
= hold the
button pressed and use the
and
buttons to adjust the brightness.
Buzzer volume
=hold the
button pressed and use the
and
buttons to adjust the buzzer volume.
Dipswitchs
SW 1..3
RS-485 address settings of the keypad
SW 4
bridge the tamper contact
ON
= bridged
SW 5
not used
SW 6
not used
EN50131 Compliance
The AlphaVision XL/ML keypad is tested en approved according to EN50131-3: 2009 by Telefication (
and complies with
Security grade 3, Environmental class 2.
WEEE-declaration
This Alphatronics product is manufactured with the most modern technology and consists of high quality
components. Most of the components used can be recycled.
The symbol means that this product should be recycled separately and not put in the normal waste bin
together with normal household waste.
This product can be handed over to your local city council disposal point, shop or supplier.
© Alphatronics B.V. – 2014
Specifications
LCD
LCD/PROX
Wieght
271g
Dimensions
165mm x 125mm x 26mm (HxBxD)
Power supply
9-15-5VDC
Current drain nominal (backlight OFF)
15mA
65mA
Current drain nominal (backlight ON)
90mA
140mA
Current drain MAX
100mA
150mA
Temperature
0 – 40°C
