Save this manual.
Keep the manual and invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
Warning:
When using tool, basic safety precautions should always be followed to reduce the risk of personal injury and damage
to equipment.
Read all instructions before using this tool!
1. Wear eye protection. When working on or around lead-acid batteries, always wear eye protection.
2. Avoid contact with Battery Acid. If splashed, immediately wash effected area with clean water.
Continue washing area until medical help arrives.
3. Connect cable to proper polarities. Connect black cable to negative body ground and red cable to positive battery terminal.
4. Use this tool in well ventilated areas. Do not attempt to jump start vehicle around flammable gases or liquids.
5. Do not allow the Black and Red clamps to touch. If this happens it can melt clamps or other metal objects.
Place them only on the corresponding terminals.
6. 12 Volt Systems Only. Use only with vehicles and boats with 12 volt electrical systems.
7. For emergency use only. Do not use this system in the place of vehicle battery. Only use to jump start your vehicle.
8. Avoid damaging Jumpstart System. Use only as specified in this manual.
9. Observe work area conditions. Do use tool in damp or wet locations. Don’t expose the rain. Keep work area well lighted.
Air compressor 12 V – 18 bar/260PSI
3
Power station
Art.Nr. 74133
portable power unit + starting aid + air compressor 12 V – 18 bar/260 PSI
Instruction manual
1 Black (negative) cable clamp
2 Red (positive) cable clamp
3 Hand
grip
4 Light
5 Volt
meter
6 Push button battery test
7 Light
on/off
switch
8 Indicator charging mode
9 Charging
plug
receptacle
10 Cigarette lighter receptacle
Operation:
1. If inflating a tire, place the hose connector on the tire valve system (A) and press the connector lever down to lock in place (B)
2. Turn the main power switch on the front panel on the On position. If inflating a ball, air mattress, or other item, place the
inflation needle or plastic adapter into the hose connector (C ) and press the connector lever down to lock in place.
Insert the adapter into the item to be inflated (D).
NOTE:
Do not over-inflate item. Check pressure gauge. Only run the compressor for 10 minutes at a time.If more air is needed, wait 20 minutes
before using again.
3. Turn Switch Off when inflation is finished.
Switch,
compressor
Pressure meter
Hose compartment
Hose connector
Inflation needle and plastic
adapters
C
M
Y
CM
MY
CY
CMY
K
B-74133-3_oMS.ai 1 09.03.09 09:21
B-74133-3_oMS.ai 1 09.03.09 09:21
