15
Powering the Spa On
Turn the power to the spa on at the main circuit breaker. Verify that the spa has no
warnings or error messages on the panel display. To verify the circulation system is in
good working order, perform the following steps:
1. Open all jets to maximum flow position.
2. Press the Jet buttons to turn the individual pumps on or off.
3. Observe and verify good water flow exists in the jets of each seat.
Upon initial start, one pump will initially come on for 5 minutes and then cycle through
each pump sequentially for a one minute duration.
Testing the RCD
The electrical service panel for the spa must be equipped with a RCD. To avoid
the risk of electrical shock, perform the following safety test before each use of
the spa:
1. Check that the power is turned on at the electrical service panel.
2. Turn on the RCD. If the RCD stays on, it is functioning properly.
DANGER RISK OF ELECTRICAL SHOCK
If the RCD fails to operate as described, there is a possibility of electric shock if the spa
is used. Shut off the power at the main electrical service panel until the source of the
problem has been identified and corrected by a licensed electrician or qualified spa
technician.
