22
Press the Light Button to set the temperature.
Modes of Operation
Ready Mode
Ready Mode will circulate water every 1/2 hour, using Pump 1 Low, in order to maintain
a constant water temperature, heat as needed, and refresh the temperature display. This
is known as “polling.”
Rest Mode
Rest Mode will only allow heating during programmed filter cycles. Since polling does not
occur, the temperature display may not show a current temperature until the heater pump
has been running for a minute or two.
Circulation Mode
If the spa is configured for 24HR circulation, the heater pump generally runs continuously.
Since the heater pump is always running, the spa will maintain set temperature and heat
as needed in Ready Mode, without polling.
In Rest Mode, the spa will only heat to set temperature during programmed filter times,
even though the water is being filtered constantly when in Circulation Mode.
Press Up Arrow (Warm) and Down Arrow (Cool) buttons until display is flashing.
Press Light Button until Mode appears.
Press Up Arrow (Warm) or Down Arrow (Cool) Buttons to toggle between Ready and
Rest.
Press the Light Button to set.
