36
Removing, Installing and Cleaning Filters
These are the steps needed to properly replace the filters. Disposable spa filters should
be replaced or non-disposable filters should be cleaned every four months.
1) Turn off all power to the spa and remove the filter lid by lifting it out towards you.
2) Turn the filter counter-clockwise and remove it from the filter well.
3) Dispose of the used filter.
4) To replace, set screen back into its place and turn clockwise to fasten. DO NOT
over-tighten.
5) Place the new filter into position and turn clockwise to fasten. DO NOT
overtighten.
6) Use of a quality filter soak product is recommended. Please contact your dealer
to purchase spa care products.
NOTE: Only use Artesian Spas approved filters. Using a Non Artesian Spa
approved filter can cause issues with the circulation system and heater and can
void warranty coverage. The filter can be upgraded to a 75 Sq. ft. filter. Please
contact Alpine Spas for further information.
WARNING: Power to the spa must be turned off prior to removing the filters. The
suction at the filter is extremely strong and can cause injury if there is no filter.
NEVER run the spa without the filters properly installed. Injury to person and
damage to the equipment can occur. Any damage to equipment due to this
circumstance will not be covered under warranty.
