OPERATION
1. Put the mist unit in your water container.
2. Connect the mist unit to the transformer.
3. Fill so the water level is ¾” above the top of the auto switch (water level
sensor)
4. Plug the transformer into the main power supply.
NOTE: The mist maker only needs TAP WATER, neither distilled water nor pure
water is permitted, otherwise the water-level sensor of the mist maker will not
operate properly when water level is low. This will cause the mist maker to
become exhausted to a point of burn out or function improperly.
GENERAL SUGGESTIONS FOR OPTIMUM USE
1. The mist unit sends up small jets of water while in operation. Your
container should be large enough to prevent water from splashing
outside the container. Do not place the unit where water spillage or
condensation will cause damage to furniture, electronic products or
floors.
2. Use of clean water is recommended. When the water is dirty, change it
with clean water in time (dirty water will affect production the mist).
3. Do not use household abrasive cleaners on any part of the mist unit.
You may clear it with soft cloth in clean water.
MAINTENANCE
1. After operating the mist unit for some time, you may notice a decrease in
the amount of mist produced or it may stop working altogether. At that
time, you should either clean or replace the ceramic disk.
2. Unplug the unit and remove from water container, clean it with soft cloth
in clean water and plug on again. If this doesn’t work, replace ceramic
disk.
SAFETY CAUTION
1. Please verify the voltage rate of the transformer with the local power
supply before use. Use the supplied specify transformer.
2. Put the transformer, the connector and the controller which attached on
the cable in a dry place or use indoor only. Take care that no water can
get into the safety transformer, the connector and the controller on the
cable along the supply line.
3. The safety transformer will heat up when in operation. Make sure there
is sufficient air circulation. Do not cover the housing.
4. Keep electrical appliances out of the reach of children.
5. Never touch the water level sensor.
6. When operating, do not let your body parts such as fingers, touch the
ceramic or put on top of it in 4”, which is not dangerous but can cause
local pains.
7. Never touch the safety transformer and the mains plug with your wet
hands.
8. Always withdraw the mains plug before touching the miniature nebulizer
or remove it from the water.
9. Avoid placing it in the immediate vicinity of electric appliances or water-
sensitive objects because a few water splashes might be produced (but
an optimal anti-splash guard is available).
