Do not use bolts or nuts in brakes or steering
systems for grounding connections
Never use bolts or nuts used in brakes or steering
systems (or any other safety-related systems) or
fuel tanks for installation or grounding
connections. The use of such parts will cause the
car controller to fail, resulting in fire and so on.
Do not install on the steering wheel or gear
lever, etc., which may hinder the operation of
the car
Otherwise, it will obstruct the front line of sight
or obstruct moving parts, etc., causing serious
accidents.
When there is a problem, please stop using it
immediately
Make sure to use only designated accessories.
The use of non-designated parts may cause
internal damage to the device, or it may not be
securely installed in place. This can cause parts
to loosen and cause danger or product failure.
Arrange the wires to avoid crimping or being
squeezed by sharp metal edges
The arrangement of wires and cables should be
far away from moving parts (such as seat tracks)
or sharp edges or corners. This will avoid
crimping and damage to the wires. If the wiring
passes through a metal hole, a rubber gasket
should be used to prevent the wire insulation
from being cut by the edge of the metal hole.
Do not install in high humidity or dusty locations
Avoid installing the device in a location with
high humidity or dust. Moisture or dust invades
the device and can cause product failure.
Precautions
Product cleaning
Please use a dry soft cloth to clean the product
regularly. If the dirt is difficult to remove, soak a
soft cloth with water only. Any other solvent may
dissolve.
Temperature
Before turning on the machine, please make
sure that the temperature in the car is between
+60°C and -20°C.
Maintain
If you encounter a problem, do not repair it
yourself. Please return this product to an
authorized Alpine dealer or the nearest Alpine
service center for repair.
Installation location
This machine cannot be installed in any of the
following places:
Near direct sunlight and heat sources
Places with high humidity and near water sources
Dusty places
Locations subject to severe vibration
Notice
This symbol indicates important instructions.
Failure to heed these instructions may result
in injury or major property damage.
from becoming obstructive while driving. Cables
or wires that obstruct or hang on the steering
wheel, shift lever, brake pedal, etc. are extremely
dangerous.
Do not splice cables
Do not cut the cable insulation to supply power
to other equipment. Otherwise, the current
carrying capacity of the wire will be exceeded,
resulting in fire or electric shock.
Do not damage the pipe or wiring when drilling
When drilling holes in the chassis for installation,
be careful not to touch, damage or obstruct the
pipes, fuel lines, fuel tanks or wires. If you don't
pay attention, it can cause fire.
Otherwise, it may cause personal injury or
damage to the product. Please return this
product to an authorized Alpine dealer or the
nearest Alpine service center for repair.
Ask professionals for wiring and installation
The wiring and installation of this product require
Use designated accessories and install securely
Do not let the cable be entangled with
surrounding objects
Arrange the wires and cables in accordance with
the requirements of the manual to prevent them
professional skills and experience. For safety
reasons, please contact the dealer where you
purchased the product for installation.
2
-
E
N
