93
-EN
ARRANGE THE WIRING SO IT IS NOT CRIMPED OR PINCHED BY A SHARP
METAL EDGE.
Route the cables and wiring away from moving parts (like the seat
rails) or sharp or pointed edges. This will prevent crimping and
damage to the wiring. If wiring passes through a hole in metal, use a
rubber grommet to prevent the wire’s insulation from being cut by
the metal edge of the hole.
DO NOT INSTALL IN LOCATIONS WITH HIGH MOISTURE OR DUST.
Avoid installing the unit in locations with high incidence of
moisture or dust. Moisture or dust that penetrates into this unit may
result in product failure.
Precautions
• Be sure to disconnect the cable from the (–) battery post before
installing your unit. This will reduce any chance of damage to the
unit in case of a short-circuit.
• Be sure to connect the colour coded leads according to the
diagram. Incorrect connections may cause the unit to
malfunction or damage to the vehicle’s electrical system.
• When making connections to the vehicle’s electrical system, be
aware of the factory installed components (e.g. on-board
computer). Do not tap into these leads to provide power for this
unit. When connecting the unit to the fuse box, make sure the
fuse for the intended circuit of the unit has the appropriate
amperage. When in doubt, consult your Alpine dealer.
• The unit uses female RCA-type jacks for connection to other
units (e.g. amplifier) having RCA connectors. You may need an
adaptor to connect other units. If so, please contact your
authorized Alpine dealer for assistance.
• Be sure to connect the speaker (–) leads to the speaker (–)
terminal. Never connect left and right channel speaker cables to
each other or to the vehicle body.
Accessory List
•
X308AU/INE-W987A .................................................................................... 1
•
Power cable .................................................................................................... 1
•
GPS Antenna .................................................................................................. 1
•
Antenna mounting plate........................................................................... 1
•
Cable clamp for antenna ..................................................................... 1set
•
USB extension cable.................................................................................... 1
•
Microphone.................................................................................................... 1
•
PRE OUT cable ............................................................................................... 1
•
Face plate (INE-W987A only) .................................................................... 1
•
CAN I/F cable ................................................................................................. 1
•
W.REMOTE cable ........................................................................................... 1
•
HDMI Fixation Bracket ................................................................................ 1
•
Flush head screw (M5×8) .......................................................................... 4
•
Screw (M5×8)................................................................................................. 4
•
Owner’s Manual ...................................................................................... 1set
Installation
Angle of installation
Install at an angle between horizontal and 30°. Note that installing at
an angle outside of this range will result in a loss of performance and
possibly damage.
To install the X308AU, refer to the manual in the separately
purchased installation kit for each car type.
Caution concerning the installation location
Caution
Do not block the unit’s fan, thus preventing air circulation. If
blocked, heat will accumulate inside the unit and may cause
a fire.
Air ventilation hole
Rear of the Unit
<example>
0 - 30°
Summary of Contents for INE-W987A
Page 2: ......
