32
-EN
Setting the Digital Output
To connect an audio processor using the optical digital output, set to
“ON” by the following procedure.
Setting item: OPT.OUT
Setting contents: OFF / ON
• Afterwards, set ACC to OFF once, then turn it ON again. The
setting of Digital Output is decided.
Setting the TV Screen Setting
Use the procedure described below to set the output screen according
to the type of TV monitor (rear monitor) being used.
Setting item: TV SCREEN
Setting contents: 4:3 LB/ 4:3 PS/ 16:9
• For some discs, the picture may not be set to the selected screen
size. (For details, refer to the explanation on the disc’s jacket.)
4:3 LETTER BOX
:
Select this when connected to a conventional 4:3 size (normal
TV aspect ratio) monitor. There may be black stripes visible at
the top and bottom of the screen (when playing a 16 : 9 size
movie). The width of these stripes will depend upon the
original aspect ratio of the theatrical release of the movie.
4:3 PAN-SCAN
:
Select this when connected to a conventional 4:3 size monitor.
The picture will fill the entire TV screen. However, due to the
mismatch in aspect ratio, parts of the movie at the extreme left
and right sides will not be visible (when playing a
16 : 9 size movie).
16:9 WIDE
:
Select this when connected to a wide screen TV. This is the
factory setting.
GENERAL Setup
General Setup Operation
The Parking Brake must be engaged to access the DVD
mode screen. Attempting to access this screen while driving
will display the warning-CAN'T OPERATE WHILE DRIVING.
The following steps 1 to 6 are common operations to each
“Setting item” of GENERAL Setup. Refer to each section for
details.
1
Press
SOURCE/POWER
.
The main menu is displayed.
2
Press
6
(
SETUP
).
The Setup mode screen appears.
3
Turn the
Rotary encoder
to select “GENERAL,”
then press the
Rotary encoder
.
The GENERAL list is displayed.
4
Turn the
Rotary encoder
to select your desired
setting item.
The screen shows the
∗
Function Guide.
* Displays the function assigned for each button (the Function
buttons).
Setting items:
MONITOR OPEN/CLOSE
↔
V.SEL KEY
↔
SPE. ANA.
↔
MULTI SESSION PLAY
↔
BEEP
↔
CLOCK
↔
CLOCK
ADJUST
↔
DAYLIGHT SAVING TIME
↔
RDS CLOCK
DISP
↔
FM LEVEL
↔
FM CONDITION
↔
PI SEEK
↔
RDS REGIONAL
↔
∗
1
DRC
↔
∗
1
DAB REGIONAL
↔
∗
1
AUTO SW DAB TO RDS
↔
PTY LANGUAGE
↔
∗
2
PHONE RECEIVE
∗
1
Displayed when the DAB Receiver Box is connected. The
DAB operation is stated in page 40 to 42.
∗
2
Displayed only when Mobile Hub (CXA-B200NK) is
connected.
Rotary encoder
SOURCE/POWER
V.SEL
7
6
2
4
1
3
5
Summary of Contents for IVA-D900R
Page 82: ......
