Alpine IVE-W560BT Owner'S Manual Download

Page: 5 / 96

-EN

NOTICE

Product Cleaning

Use a soft dry cloth for periodic cleaning of the product. For more
severe stains, please dampen the cloth with water only. Anything
else might dissolve the paint or damage the plastic.

Temperature

Check that the temperature inside the vehicle is b40°C
(+104°F) and 0°C (+32°F) before turning your unit on.

Moisture Condensation

You may notice the disc playback sound wavering due to
condensation. If this happens, remove the disc from the player and
wait about an hour for the moisture to evaporate.

Damaged Disc

Do not attempt to play cracked, warped, or damaged discs. Playing
a faulty disc could severely damage the playback mechanism.

Maintenance

If the unit appears faulty, do not attempt to repair it yourself.
Return it to your Alpine dealer or the nearest Alpine Service
Station for servicing.

Never Attempt the Following

Do not grip or pull out the disc while it is being pulled back into
the player by the automatic reloading mechanism.
Do not attempt to insert a disc into the unit when the unit power
is off.

Inserting Discs

Your player accepts only one disc at a time for playback. Do not
attempt to load more than one disc.
Make sure the label side is facing up when you insert the disc.
“Disc error” will be displayed on your player if you insert a disc
incorrectly. If “Disc error” continues to be displayed even though
the disc has been inserted correctly, push the RESET switch with a
pointed object such as a ballpoint pen.
Playing a disc while driving on a very bumpy road may result in
skips, but this will not scratch the disc or damage the player.

Irregular Shaped Discs

Be sure to use round shaped discs only for this unit and never use
any specially shaped discs.
Use of specially shaped discs may cause damage to the mechanism.

New Discs

To prevent the disc from jamming, “Disc error” is displayed if
discs with irregular surfaces are inserted or if discs are inserted
incorrectly. When a new disc is ejected immediately after initial
loading, use your

nger to feel around the inside of the centre

hole and outside edge of the disc. If you feel any small bumps
or irregularities, this could inhibit proper loading of the disc. To
remove the bumps, rub the inside edge of the hole and outside
edge of the disc with a ballpoint pen or other such instrument, then
insert the disc again.

Centre Hole

Bumps

New Disc

Outside
(Bumps)

Installation Location

Make sure the IVE-W560BT/IVE-W560BT-R is not installed in a
location subject to:

• Direct sun and heat
• High humidity and water
• Excessive dust
• Excessive vibrations

Correct Handling

Do not drop the disc during handling. Hold the disc so you do
not leave

ngerprints on the surface. Do not af

x tape, paper, or

gummed labels to the disc. Do not write on the disc.

CORRECT

INCORRECT

CORRECT

Disc Cleaning

Fingerprints, dust, or dirt on the surface of the disc could cause the
DVD player to skip. For routine cleaning, wipe the playing surface
with a clean, soft cloth from the centre of the disc to the outer
edge. If the surface is very dirty, dampen a clean, soft cloth in a
solution of mild neutral detergent before cleaning the disc.