11
-EN
Display example for FM Radio main screen
[DX SEEK]
*
1
button: Displays the tuning mode selection
list.
Displays the preset number
*
2
/frequency.
*
1
The button displays the current tuning mode.
*
2
Displayed only when the current station is the preset one.
Listening to the Radio
1
Press
SOURCE
to activate mode switching
screen.
2
Slide the display horizontally with your finger to
select Audio/Visual mode.
Each time you slide the display, the mode switches
circularly in the following order:
Audio/Visual
Navigation
Camera
Telephone
Multi Info
Audio/Visual
3
Slide the display vertically with your finger, or press
SOURCE
repeatedly to select RADIO source.
4
Press
/ENTER
.
The RADIO source is activated and the display changes to
the RADIO main screen.
5
Touch
[BAND]
to select the desired radio band.
Each press changes the bands as follows:
6
Touch
[DX SEEK]
to choose the tuning mode.
•
There are two modes you can select for auto tuning, DX and Local:
-
DX (Distance) mode ;
Both strong and weak stations will be tuned in.
-
Local mode ;
Only strong stations will be tuned in.
The initial setting is DX.
•
Press
/
/TUNE/A. ME
can also change the turning mode.
7
Touch
[
]
,
[
]
or
[
]
,
[
]
to change the
radio frequency up or down respectively.
In manual mode, touch and hold to change the frequency
continuously.
Presetting Stations Manually
1
Tune in a desired radio station you wish to store in
the preset memory by manual or automatic seek
tuning.
2
Touch
[PRESET]
to display the list screen of preset
stations.
3
Touch and hold any one of the preset stations (1
through 6) for at least 2 seconds.
The current station is stored.
4
Repeat the procedure to store up to 5 other stations
onto the same band.
To use this procedure for other bands, simply select the
desired band and repeat the procedure.
A total of 30 stations can be stored in the preset memory
(6 stations for each band; FM1, FM2, FM3, MW or LW).
•
Touch
[
]
to cancel the list screen of preset stations.
•
If a preset memory has already been set in the same preset number, it
will be cleared and the new station will be memorized.
Presetting Stations Automatically
The tuner can automatically seek and store 6 strong stations in the
selected band in order of signal strength.
After selecting the desired band, touch and hold
[A.MEMO]
for at least 2 seconds.
The tuner automatically seeks and stores 6 strong stations into
preset station 1 to 6 in order of signal strength.
When the automatic storing has been completed, the tuner goes
to the station stored in preset location No.1.
•
The operation can also be performed by pressing and holding
/
/TUNE/A. ME
button for at least 2 seconds.
•
If no stations are stored, the tuner will return to the original station
you were listening to before the automatic storing procedure began.
Tuning to Preset Stations
You can tune in the preset stations in memory on each band using the
preset number.
1
After selecting the desired band, touch
[PRESET]
to
display the list screen of preset stations.
2
Touch any one of the preset stations (1 through 6)
that has your desired radio station in memory.
The preset station is received.
•
Touch
[
]
to cancel the list screen of preset stations.
Radio
FM-1
FM-2
FM-3
MW
LW
FM-1
DX SEEK
LOCAL SEEK
MANUAL
