62
-EN
Installation
Caution concerning the installation location
1
Remove the mounting sleeve from the main unit (see
“Removal” on page 62).
Slide the mounting sleeve into the dashboard and fix
it with the metal shackles.
*
1
If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
*
2
The supplied face plate may be mounted.
Removal
1. Insert the bracket keys into the unit, along the guides
on either side. The unit can now be removed from the
mounting sleeve.
2. Pull the unit out, keeping it unlocked as you do so.
2
When your vehicle has the Bracket, mount the long
hex bolt onto the rear panel of the iXA-W404R and
put the Rubber Cap on the hex bolt. If your vehicle
does not have the Mounting Support, reinforce the
head unit with the metal mounting strap (not
supplied). Secure the ground lead of the unit to a
clean metal spot using a screw (
*
1
) already attached
to the vehicle’s chassis. Connect all the leads of the
iXA-W404R according to details described in the
CONNECTION section.
•
For the screw marked “*
2
”, use an appropriate screw for the chosen
mounting location.
Mounting Sleeve
(Included)
Dashboard
Rubber Cap (Included)
Face Plate
*
2
(Included)
This unit
Hex Bolt
(Included)
Bracket
Pressure
Plates
*
1
Hex Nut (M5)
Screw
Bolt Stud
This unit
Chassis
Ground Lead
Metal
Mounting
Strap
*
2
*
1
3
Slide the iXA-W404R into the dashboard until it
clicks. This ensures that the unit is properly locked
and will not accidentally come out from the
dashboard.
This unit
Bracket keys
(Included)