Before reading instructions below, this light MUST be used with a Quick Connect
Cable and transformer.
Recommended to use light fixture with an Alpine Quick
Connect Cable and transformer.
Assembly:
.
STEP 1:
Assemble the Luminosity™ light fixture
as shown in the diagram to the right.
STEP 2:
Decide on a desirable place to stake
Luminosity™ light. Be sure the desired location
is debris/rock free and is at least 10ft. away from
pools, spas or fountains. Loosen and soften the
dirt with a shovel or by adding water.
STEP 3:
Insert the stake of the Luminosity™
Light fixture into the ground by pushing the stake
Gently into the ground. To avoid damage to your
Luminosity™ light fixture, do not use a hammer or
push down from the top of the light pressure. Plug
the Luminosity™ light fixture into a Quick Connect
Cable
(sold separately). Please see diagram below
for details.
●
Before plugging in the unit, be sure the input voltage indicated on your
transformer is the same as your local power supply. If not, please do not
operate the light until you obtain the appropriate transformer from your
local dealer.
•
To reduce the risk of electrical shock, inspect all cords for damage before
installation.
•
Plug the connector of the Luminosity™ Light into the socket on the
transformer or Quick Connect Cable and screw the coupling until tight.
•
Plug the transformer into the nearest 120-volt outlet. Your Luminosity™
Light should light up.
•
Check that the light set is getting power by testing another applicant in the
power outlet that the lights use.
•
Check to ensure that your light bulb has not burned out from usage.
•
If water gets into any of your Luminosity™ Lights, lift it out of water, remove
the lampshade, and empty the water until dry.
o
This product is not a toy and must not be operated by children.
o
To connect to the main low voltage cable, the low voltage cable
should be buried 6 inches maximum.
o
Do NOT connect the low voltage cables with wet hands.
o
Must be used with low voltage landscape lighting equipment.
o
Do NOT exceed the voltage and wattage indicated on the transformer.
o
Do not assemble this product with submersible or pool/spa
equipment.
o
Do NOT install within 10 feet of pools, spas or fountains.
o
Store the unit in a dry place if not in use for an extended period of
time.
Inserting and Assembling Luminosity™
Light
Using Your Luminosity™
Lights the First Tim
If Your Luminosity™
Light Fails to Illuminate
Caution: Risk of fire or electrical shock
Jolie
Products,
Inc
