8
Routing the antenna cable.
1. Route the cable using the provided cable clamps to take up
the cable’s slack.
2. Use the waterproof pad when running the cable under the
vehicle’s rubber gasket.
3. Attach the cable at several points using the remaining cable
clamps.
Cable
clamps
2. Connections
Disconnect the battery (–) terminal.
Note:
Some vehicles contain a vehicle control computer etc. in this case, contents of
the computer memory may be erased when the battery (–) lead is disconnected.
Water
proof pad
6
1
Connect the power lead to this unit.
Insert until a click sound is heard.
2
Wrap electrical tape around end of leads not used.
Connect the battery (–) terminal and turn the ignition key to the ACC or ON posi-
tion. Check to see if operation can be performed properly.
(Is the power turned on? Is the illumination turned on?)
You can check the language selection menu with the monitor. (Refer to the Owner’s Manual for details.)
ON
3
4
