42
Harmful Substances
Names of harmful substances contained in the product
Installation and Connection
Before installing or connecting the Media Player, please read the following instructions and refer to the "Operating
instructions" to ensure proper use.
Warning
Please make the correct connections.
Improper connections may cause fire or damage to the product.
P
lease only use in vehicles with 12V negative grounding.
(If you are not sure, please confirm with the agent). Otherwise, it may cause fire and other accidents.
Before wiring, please remove the cable connected to the negative terminal of the battery.
Failure to do so may result in electric shock or injury due to a short circuit.
When drilling, please pay attention not to damage the conduits or wires.When drilling mounting holes
in the chassis, take special care not to touch, damage, or obstruct conduits, fuel lines, the fuel tank, or
electrical wiring. Failure to do so may result in fire.
Do not use any of the bolts or nuts on the brake or steering system for grounding connections. Bolts
or nuts used on the braking or steering system (or any other safety-related system), or on the fuel
tank,
should never be used to install or connect a grounding wire. Failure to abide by this could cause
the vehicle controls to malfunction or cause a fire, etc.
Part name
Harmful substance or element
Lead
(Pb)
Mercury
(Hg)
Cadmium
(Cd)
Hexavalent
chromium
(Cr(VI))
Polybrominated
biphenyls
(PBB)
(PBDE)
Circuit board assembly
×
О
О
О
О
О
О
О
О
О
О
О
×
О
О
О
О
О
×
О
О
О
О
О
Polybrominated
Diphenyl Ether
Housing assembly
Display component
Accessories
This table is prepared in accordance with SJ / T 11364.
O
:
indicates that the hazardous substance is present in all homogeneous materials of the part at or below the limit specified in GB/T 26572.
X
: indicates that the hazardous substance is present in at least one homogeneous material of the part in excess of the limit specified in GB/
T 26572.
For parts marked with "X", the content is exceeded because there is currently no mature substitute technology available in the industry.
Do not cut the cable.
Do not supply power to other devices by stripping the cable insulation. Doing so may cause fire or
electric shock by exceeding the rated load of the cable.