4
Power on and off
Press any button on the host controller to turn on the device.
Press and hold
for at least 2 seconds to turn off the device.
Note:
When the device is powered on for the first time, the volume level is 12 at the start
Set the sound mixing mode
This device is equipped with a high quality audio processor chip. You can choose ALPINE Direct mode to enjoy
the high quality signal source of this device, or you may choose AUX Mix mode to enjoy the signal source of
this device and listen to the sound of the original on-board device (such as the navigator) simultaneously.
Press
to switch the sound mixing mode. Take AUX Mix as an example below:
AUX Mixo ↔ ALPINE Direct
AUX Mix:
While this device is playing music, the music or navigation prompt being played in the original on-board
speaker is mixed together to play.
ALPINE Direct:
Only enjoy the high quality music played by UTX-M08S.
Note:
When the same audio source is superposed, the auxiliary audio source is invalid. That is, when the
current audio source is AUX, AUX Mix mode is invalid.
Prior to using this function, the audio output of the original on-board speaker should be correctly
connected to the AUX IN port of this device.
Signal source selection
Press
+ to change the signal source.
USB*
1
(default audio source) ↔ Bluetooth
*2
↔ High level ↔AUX
*1 When three USB storages are connected to this device, the audio files in them will be played in a
consolidated USB audio source.
*2 Only display when connected with “Bluetooth”, refer to “Bluetooth connection”.
Initial system startup
RESET switch. Press and hold it for 3 seconds and the host machine will restart.
1 Power off the device.
2 Press RESET with a ballpoint or a similar pointed object.
RESET switch
