11
the IP address of the b@home gate.
If you are not able to establish a connection to the b@home gate, check the network connection and the settings
of your router (also see Section 6. System requirements).
14.1.2 b@home app
The b@home app is available for free from the App Store (iOS 7.0 or higher) or Google Play Store
(Android 2.2 or higher).
For security reasons, the mobile end device has to be authenticated. This is a one-off process (see on-screen
instructions).
If you are not able to establish a connection to the b@home gate, check your network connection and/or the settings
of your router (also see Section 6. System requirements).
14.1.3 b@home portal
Once you have set up Internet access via the b@home gate’s configuration interface (see 14.9),
you can go to https://www.klimaregler.de on the b@home portal to undertake settings on your
system.
14.2 Name in network (host name)
If you are using just one b@home gate in your network, no changes are needed.
If further b@home gates are to be operated in the same network, before starting up another b@home gate, you need to
change the destination address http://bathomegate/ (e.g. into http://bathomegate1/) because the same destination
addresses are not permitted in a network.
14.3 System functions
State the functions your temperature control system can perform:
•
heating
•
cooling
•
heating and cooling
These settings depend on the type of temperature control system and the actuators (receivers) used. An incorrect
selection may result in damage to the system and increased energy consumption.
14.4 Designation of the b@home gate
Any name can be entered and is displayed in the b@home app and b@home portal.
IP address (example):
http://192.168.0.100
i
i
App
Portal
i
Gate
!
Gate
App
Portal
Gate
App
i
