8
9. Illuminated displays
The b@home gate has illuminated displays (LED) on the front to indicate the various operating statuses.
Lamp
Type of
display
Status
designation
Description
Duration of display
█ █ █ █ █ █
Flashing red
Train sensor
The b@home gate has been asked to
accept a train telegram for a sensor.
30 seconds,
on standby for training
then ends
████████
Lit up green
Sensor has been
trained
A training telegram was received when
in “Train sensor” status.
3 seconds,
confirmation that
training was successful
█ █ █ █ █ █
Flashing red
Cancel sensor
The b@home gate has been asked to
remove a sensor, which is transmitting a
cancel telegram.
30 seconds,
on standby to cancel
then ends
████████
Lit up red
Sensor has been
cancelled
A cancel telegram was received when in
“Cancel sensor” status.
5 seconds,
confirmation that
cancellation was
successful
█ █ █ █ █ █
Flashing
yellow
Train actuator
The b@home gate has been asked to
transmit training telegrams for an
actuator
5 seconds,
during this time, the
b@home gate
transmits train
telegrams
█ █ █ █ █ █
Flashing blue
Device authentication
An unknown end device (e.g.
smartphone) or a PC is attempting to
access the b@home gate and is asking
for writing approval
1 minute
████████
Lit up yellow
Check
system
The b@home gate is reporting a status,
which should be remedied by the user
(lost connection, battery flat) – the user
should establish a connection with the
b@home gate (e.g. via a smartphone)
for more information
Permanently,
until the status is
remedied
█ █ █ █ █ █
Flashing blue
Firmware update
The firmware is being updated.
Until the firmware
update is complete
████████
Lit up red
No portal connection
Even though the user has confirmed he
or she wants to use the b@home portal,
the b@home gate is not able to establish
a connection with the portal server
Permanently,
until the status is
remedied
█ █ █ █ █ █
Flashing red
(both lamps in
turn)
Factory reset
The b@home gate has been asked to
reset all settings to the state they were in
upon delivery
and waits for confirmation in the form of
a button being pressed
10 seconds,
request is ignored after
this time
████████
Lit up green
Start initialisation
Initialisation phase after the b@home
gate has been connected to the power
supply.
Until initialisation is
complete
████████
█ █ █ █ █ █
Lit up red or
flashing
Device defect
An unknown error has occurred. Please
contact your installation company or
your dealer.
Permanently,
until the status is
remedied
████████
Lit up blue
Duty cycle
reached
The b@home gate is reporting that the
wireless transmission is being paused
due to the duty cycle limit.
Permanently until the
duty cycle is no longer
exceeded after an hour
at the latest (see
Section 16.8)
