60 Watt Transformer
WARNINGS AND CAUTIONS
WARNING
• Risk of Electrical shock. Install only to a
covered Class A GFCI receptacle that has an
enclosure that is weatherproof with the
attachment plug cap inserted or removed.
• Risk of Electrical shock. Mount the unit at a
height greater than 1 foot from the ground
surface.
• Risk of Fire. Installation involves special wiring
methods to run wiring through a building
structure, consult a qualified electrician.
• Risk of electric shock, do not remove the cord
and strain relief.
• Do not remove the grounding pin from the
power cord plug.
• Do NOT submerge the Transformer.
•
Risk of electrical shock
– This submersible
light kit has not been investigated for use in
swimming pool or marine areas.
CAUTION
• This light kit has been evaluated for use in or
above water only.
• Use a proper power source as indicated on the
Transformer label.
• Keep the cord away from high temperatures or
other heat sources.
• TRANSFORMER CAPACITY: Make sure that
the total number of lights connected to the
Transformer does not exceed the transformer
60-watt output capacity.
• Do not use lights in water less then 50° F or
exceeding 104° F.
• Do not use with a dimmer.
• The light is not to be used in swimming pools or
spas.
• Lighted lamp gets hot quickly!
• Do not touch hot lens, guard or enclosure.
LIMITED WARRANTY
This warranty is offered to you as an extra benefit
and does not affect your rights as a consumer in
any way. This unit has been checked for
compliance to performance requirements at the
time of manufacture and are made in accordance
with the requirements set forth in UL1310 to
insure safe operations over the life of the product.
This light kit is warranted against manufactured
defect for one (1) year from the date of purchase.
Proof of purchase is required for all warranty
claims. The warranty is not valid if defects are
caused by tampering, negligence, misuse or not
observing safety warnings. No responsibility is
assumed for indirect damage that may result from
the use of this appliance.
The warranty does not apply to or cover damages
or defects caused by external causes, including,
but not limited to, improper or faulty installation or
unauthorized modification, lightning, electrical
surges, abuse, misuse or abnormal use or
misapplication, including use in a manner
inconsistent with the product’s intended function.
The purchaser is responsible for determining the
suitability of the product for its intended use. If
products are damaged in transit, a claim should
be filed with the carrier.
This warranty does not cover the AG-85 high
intensity halogen bulb.
ASSEMBLY INSTRUCTIONS
1.
(Fig. 1)
Using the 3-way adaptors and the 13-
foot 2-way extension cord connect all lights as
shown. Press each plug so it is firmly seated and
hand tighten the nut from the plug to each socket.
2.
(Fig. 2)
Connect the lights to the sensor by
pushing the plug into the sensor socket until it is
firmly seated. Hand tighten the nut from the plug
to the socket.
3.
(Fig. 3)
Connect the sensor to the transformer
by pushing the plug into the transformer socket
until it is firmly seated. Hand tighten the nut from
the plug to the socket.
4. Place the lights in or out of the water. DO
NOT SUBMERGE the transformer and sensor.
Make sure the light sensor faces up.
NOTE: At night, the lights will automatically turn
on. At sunrise, they will automatically turn off.
4.
(Fig. 4)
Plug the transformer into a properly
grounded electrical outlet.
2-way extension
cord (13-foot)
3-way
adaptor (2)
4 weighted watertight
submersible lights with
16-foot cords
Fig. 1
Fig. 2
Sensor
Plug from
lights
Fig. 3
Plug from
sensor
Photo-eye must face up
to receive light during
daytime
GFCI
Fig. 4
