ALS Tire BLE Install Guide
4
© Alsense Motorsport SRL
3.
Quick Install
a.
Initial Setup
First step after receiving the product is putting the sensors on charge using the supplied cables and
any USB adapter (including external batteries).
b.
Configuration
Full information on configuring the parameters of the units can be found in section
c.
Power-up
The system can now be powered up. To power up the device remove it from the magnetic enclosing.
Once removed the device automatically boots up, the STATUS LED on the device should turn blue
and, after the initialization period passes, it switches off. This signals that the device is ready for
transmitting data over BLE.
d.
Sleep Mode
The device will be advertising itself on Bluetooth for 15 minutes, after this period if no connection
is received then it will enter a sleep mode for 1 hour and then wake up and re-advertise. Any BLE
connection to the device will reset this timer. The device will repeat this pattern until the battery is
depleted. Use a magnetic override or pad to wake up the device if it has entered sleep mode(check
the STATUS LED on wake-up to make sure the battery is not depleted).
