ALS Tire BLE Install Guide
5
© Alsense Motorsport SRL
4.
Physical Installation
Figure 1 – Mounting (sensor – left, receiver –
right)
The sensor should be mounted in its final position using the mounting holes situated on the sides
of the housing. For temporary installs we’ve successfully used 3M Dual-Lock tape, but extra care
should be employed when using such a solution.
We do recommend placing the sensor on the tire’s leading edge (so as to not get hit by debris) and
avoiding direct exposure to significant heat sources (i.e. exhausts).
The IR sensor has a horizontal FOV of 110°. As the sensor is placed further away, the maximum
width of the tire increases. Please consult the table and the graph below or get in touch if you have
any questions. Please consult ‘Figure 2’ in order to determine how to orient the sensor.
For best wireless range please ensure that the receiver and sensors are all oriented
vertically.
