Installation
Installation
Assembly of th
Assembly of the circuit b
e circuit breaker on-
reaker on---site
site
G31--201EN12
G31--201EN12
5/20
5/20
04--2011
04--2011
© ALSTOM 2010. All rights reserved. Informat
© ALSTOM 2010. All rights reserved. Information contained in
ion contained in this document is indicative only. No
this document is indicative only. No representati
representation or
on or warrant
warranty is
y is given or should
given or should be
be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liabili
provided without liability and
ty and is subject to
is subject to change without notice. Reproduction, use or disclosure to
change without notice. Reproduction, use or disclosure to third parties, without express writt
third parties, without express written authority, is
en authority, is
strictly prohibited.
strictly prohibited.
GRID
GRID
Installing
Installing the circuit
the circuit ----breaker -
breaker --
- Step 1
Step 1
Positionning
Positionning
Presen
Present t the
the assemb
assembly
ly to
to the
the floor
floor on
on its
its anchor
anchoring
ing points
points after
after having
having added
added
10 mm of shims under the frame/ controls assembly.
10 mm of shims under the frame/ controls assembly.
.
.
A
A
VS...GAD01D
VS...GAD01D
Circuit-breaker
Circuit-breaker
General arrangement
General arrangement
.
.
A
A
Fixing to the ground
Fixing to the ground
and checks flatness
and checks flatness
Z
Z
= IPB axis to the ground
= IPB axis to the ground
---
- Pre-
Pre--t
-tightening of fixings.
ightening of fixings.
---
- Check the lev
Check the levels by using a viewing lens (ins
els by using a viewing lens (insert shims if required
ert shims if required
evenness
evenness
±
±
1mm
1mm
), and tightening to the required torque levels.
), and tightening to the required torque levels.
.
.
A
A
VS...GAD01D
VS...GAD01D
Circuit-breaker
Circuit-breaker
General arrangement
General arrangement
Z
Z
evenness
evenness
±
±
1mm
1mm
Continued on next page.
Continued on next page.
Summary of Contents for FKG1X
