Maintenance
Replacing the electrical contact densimeter
G51--161EN02
1/4
02--2011
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is
strictly prohibited.
GRID
Presentation
Introduction
After inspection of the electrical contact densimeter threshold, if one of the
thresholds does not comply with the specified value, replace the densimeter.
State of densimeter
The densimeter has been checking and its volume is isolated from the pole
SF
6
gas volume.
In this module
The replacing of the electrical contact densimeter must be done in several
steps :
Step
Topic
Page
A
Removing the densimeter
2
B
Installing the new densimeter
3
C
Placing the densimeter in communication with the SF
6
volume
4
Summary of Contents for FKG1X
