Maintenance
Replacement of enclosure cover seals
G51--202EN06
6/6
11--2011
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is
strictly prohibited.
GRID
Preparing and installing static seals
Process for
FKG1XP / XV / XW
The table below gives the steps of replacing cover seals :
Step
Action
Comment
6
Fit the seals by folding over
theextremities into theslots
in the cover
seal
7
Removetheprotection gas-
kets
Refer to the procedure
“Connection with prepara-
tion of contact surfaces”,
see summary for reference
(...31-50.).
1.6 daNm
Vaseline
HM8--30
1XP / 1XV / 1XW
x6 / x6 / x6
x8 / x8 / x8
x4 / x4 / x4
.
B2 =
.
B3 =
.
B1 =
.
A
.
B2
.
B1
.
B1
.
A
.
B3
Summary of Contents for FKG1X
