Altana 0470, Manual

8

4 Operation

MEASUREMENT OPERATIONS
1. Hold the meter by its Handle Grip and point it toward the surface 

to be measured.

2. Pull and hold the Trigger to turn the meter on and begin testing. 

The display will light if the battery is good. Replace the battery if 
the display does not light.

3. Release the Trigger and the HOLD display icon will appear on the 

LCD indicating that the reading is being held. In HOLD status, press 
the laser button to turn on or off the laser. Press the buzzer button 
to turn on or off the buzzer. Press the MIN/MAX button to display 
the minimum and maximum temperatures.

4  The meter will automatically power down about 10 seconds after 

the trigger is released.

Switching °C/°F 
  Press the °C/°F button two seconds until the °C/°F symbol changes.
Switching Max/Min
  Press the Max/Min button.
Switch on/off laser
  Press the laser button
Switch on/off buzzer
  Short press the °C/°F button
Find Max/Min
  If the buzzer is turned on, when BYK t200 finds the Max/Min value, 
  the buzzer will beep.

BATTERY REPLACEMENT 
If battery power is not sufficient,
the low power symbol will be displayed.
Replace with one new 9V alkaline battery.
Open the battery cover by squeezing the 
rubber grip below the display and 
pull forward.